APP Modified Bitumen Waterproof Membrane-Modified Bitumen Waterproof Membrane-HUAGUANG SINORGCHEM WATERPROOF MATERIALS LIMITED BY SHARE LED.

APP modified bitumen waterproof membrane is made by soaking the base in bitumen, or thermoplastics (such as a tactic polypropylene-APP,APAO.APAL) modified bitumen, then covering double faces with thermoplastic elastomer (SBS)modified bitumen, and last finishing the upward face with fine sands, mineral slates or polythene membrane etc. While downward face with polythene membrane surface.

A. Upper Surface: Polyethylene (PE) Film / Fine Sand / Mineral Particle / Aluminum Film

B. Modified Bitumen

C. Reinforcement: Polythene / Fiberglass / Fiberglass Polyester

D. Modified Bitumen

E. Lower Surface: Polyethylene (PE) Film

·Roof and underground in industrial and civil buildings

·Bridge, subway, tunnel, swimming pool, etc.

·Waster landfill, sewage plant, irrigation system,etc.

Executive Standard GB18243-2008

SN	Items			I		II
				PY	G	PY	G	PYG
1	Soluble Content / (g/m2) ≥		3mm	2100				-
			4mm	2900				-
			5mm	3500
			Test Phenomenon	-	Base Inflammable	-	Base Inflammable	*
2	Heat Resistance		°C	110		130
			≤mm	2
			Test Phenomenon	No Flowing or Dropping
3	Low-temperature Flexibility °C			-7		-15
				No Fissure
4	Imperviousness 30min			0.3MPa	0.2MPa	0.3MPa
5	Tensile Strength	Maximum Peak Tension / (N/50mm) ≥		500	350	800	500	900
		Secondary Peak Tension / (N/50mm) ≥		-	-	-	-	800
		Test Phenomenon		No Fissure with Bitumen Coating or Separation between Bitumen Coating and Base Layer in Tension Test
6	Elongation	Maximum Elongation / % ≥		25	-	40	-	-
		Secondary Elongation / % ≥		-		-		15

Construction Method

Make sure the roof deck smooth, and dry (moisture<9%), then apply the surface oroof deck homogeneously with a kind bitumen paint, till dry to start application.

There are two methods in application:

a./One way is by heating and melting method. Heat the polyethylene film of the membrane and roof deck surface by heating and melting method to be nearly melted (not flowing), then install the membrane filly bonded to the roof deck with overlaps of 5-10cm.

b. /The other way is by cold adhesive method. Pour the cold adhesive homogeneously on the roof deck, then roll the membrane to install it to be fully slicked to roof deck.By heating and melting method and by cold adhesive can be used in alternation in application as requested.
After application, a full serious inspection is required to sure no air bubble, no falling away, etc. to guarantee the waterproof life.

·Good impermeability and waterproof performance

·high tensile strength, elongation rate, and size stability to perfectly fit substrate distortion and crack

·specially suitable to high temperature and of strong sun-shining

·Anti-puncture and anti-broken, anti-resistant, anti-corrosion, mildew resistant and weather resistant

·Hot melt construction, solid and long-lasting